Below Steps tell you how to install a MonoBlock Inb on your
satellite dish for satellites Dish TV 95 Degree,(NSS6) and AsiaSat 100.5
First check if your dish is compatible with a MonoBlock.
You should have an 80cm dish without multi feed adaptor.
Mount the MonoBlock properly on to the dish. It's
very important that you mount the left device on the dish, if you stand behind
the dish a look into the sky. The left eye should now be in the center of the
dish. These points to NSS6
Now, set the correct DiEqC settings
in all connected receivers. Most
Monolock LNBs use DiEqC A/1 for nss6 and DiEqC B/2 for AsiaSat 100.5..
You should find these settings in the installation menu
or under "dish settings" or "Lnb settings" on your receiver.
Now align the dish to NSS6(95
Degree). First set the right elevation for
your location. There are several websites to find out the proper elevation for
your location. Then move the dish slightly from south to south-east until you
have signal strength and signal quality on your receiver. You should find
signal indicator in the same menu as you can set the DiEqC settings.
Get the best signal as possible. You should reach at least 80% signal strength and quality
to get a good signal.
Now, if you found the satellites and
have enough signal, you can do a channel scan on both satellites.
